Swimming pools are most commonly used for recreation. It is one of the best structure for leisure activities and relaxation. Similarly, it is also known to be used for exercise and sports. Interestingly to discuss with is the inground pool since it is most common pools as seen in many places. It has four different types which are concrete plaster pool, fiberglass, vinyl-lined and other alternative finishes. The most popular among these four types is the concrete plaster pool.

Concrete plaster pool is made out of steel-reinforced concrete which strengthens and holds the concrete in tension between the outer shell and the plaster which is generally used for protective or decorative coatings of pool walls, and it is the waterproofing layer to keep the inground pool structure to a longer time.

Over the years, it will come to the point that plaster may run-down, rough, stained or scarred. Water balance could be the main reason for the damage where chemicals put into the water is degrading the finish as time passes by and frequent time it is being used. True enough, plaster is a natural material and can be expected to deteriorate.

Swimming pool replastering is done during pool renovation and maintenance. It can be done more often to keep the fine finishes. The replastering results in a more uniform look of the entire pool. It will definitely strengthen the structure of the pool after the swimming pool replastering. Importantly, the swimming pool can be checked if it works efficiently.

The process is tedious if the entire swimming pool is subject to replastering and can cost a lot but depending on the materials to be used. Companies like the pool resurfacing company orange county ca offer replastering services which are convenient but sure need to spend a lot of money.

Here are the brief steps for swimming pool replastering:

1. Remove the old pool plaster. Drain the water out of the swimming pool and clean the pool surface. Start to remove the plaster with the use of jackhammers or air chisel. It is important to remove the plaster without creating a lot of hollow carves. Make it smooth as much as possible and make use of sandpaper to remove sharp edges

2. Wash the pool surface with acid. It has to be done carefully as a muriatic acid need to be poured directly onto the entire pool surface. Once dry, wash off the acid by the pressurized water hose. The basic purpose of acid washing is to remove the leftover old plaster and make the surface rough so the new plaster will stick onto it properly. Use of appropriate gear is a must before performing this step as this is hazardous.

3. Apply the new plaster. This step might take 2-4 hours and must be completed in the shorter time possible. Mix the plaster into a container and apply it evenly to the pool surface through the use of steel finishing trowel. Apply another coat after the first dried coat. Ensure an even surface at the wall and floor of the pool. Paint it for finishing touches with the correct type of paint especially used for concrete plaster pools. After it has completely dried, the pool can now be filled with water.

What is swimming pool replastering?